File Photo
Now non-woven fabrics are used in all areas of life, so the production of non-woven fabrics must be inseparable from non-woven machinery. Non-woven equipment has a corresponding process of operation, especially before using non-woven equipment, it is necessary to make adequate preparations. These preparations are very important. In general, we present below the preparations before using non-oven equipment. Let's take a look.
1. First, put the rewinding roller before the start of the non-woven equipment, first start the main engine power and frequency conversion controller, and then slowly rotate the frequency conversion speed control switch.
2. If you want to count in the production process, you can set the number of pieces or meters you need on the counter at will.
3. According to the requirements of different non-woven fabrics, adjust the tension on both sides of the non-woven fabric to get the desired elastic non-woven fabric.
4. If the non-woven fabric needs to be punched, and the punching is not uniform, it can be adjusted by the adjustment device of the spiral punching knife until it is uniform.
5. During trial operation: After starting the machine, increase the speed appropriately and observe whether the combination of the above steps results are normal. If not, continue adjusting the previous steps; If it is normal, set the production speed to the folded state of the machine.
Before using non-oven equipment, the above preparations must be completed before carrying out follow-up work. After using non-woven equipment, be sure to check for defects. If there is a defect, you must report it for repair. If there is no fault, it can be used normally. In addition, non-woven equipment needs to be maintained properly, and pay attention to the condition of the machine during use.
Source: Online/NAN
Comment Now