File Photo
The bigger the non-woven fabric manufacturer, the more they understand the importance of preparation work before making the non-woven fabric. Good work in non-woven fabric pre-production work can not only ensure the processing quality of non-woven fabric but also reduce errors and emergencies in various links of the production process, which is conducive to the improvement of production. and processing efficiency of non-woven fabrics. So what preparations do you need to make before producing non-woven fabric?
1. Put the rewinding stick in place, first start the power and frequency conversion controller of the host machine, and then slowly rotate the frequency conversion speed control switch.
2. If you need to count, you can set the desired number of pieces or meters on the counter.
3. According to the characteristics of different non-woven fabrics, adjust the two tension of the fabric so that the fabric is neither tight nor loose.
4. If the non-woven fabric is not punched evenly, it can be adjusted through the adjustment device of the spiral punching knife until it is uniform.
5. If the non-woven fabric is not too loose or tight, it can be adjusted by the non-woven fabric air pressure adjustment device.
6. Run trial operation: After starting the machine, increase the speed appropriately and observe whether the results of the combination of the above steps are normal. If not, continue adjusting the previous steps; If normal, set the production speed to the machine fold state.
Before the production and processing of non-woven fabric, the preparation work that needs to be done must be taken seriously, because if the initial preparation is not sufficient, it will affect the smooth progress of the production and processing of non-woven fabric products. So do not rush to ignore the initial preparation!
Source: Online/NAN
Comment Now